shopping_cart Your Basket (0)
Currency:

Replacement Sensor For Eutech Elite CTS Tester

Dipslides accepts credit/Debit card, PayPal and Bank Transfer

Please note, this listing is for the replacement CTS sensor only, not the tester.

$23.30
Worldwide shipping available
Pay via Credit/Debit Card, PayPal or bank transfer online. PO number can be added during checkout if required.

Sensor Type
Quantity

About the replacement sensor for eutech elite cts tester

Elite CTS Replacement Sensor (Pin or Cup)

This is a replacement sensor module for the Elite CTS tester. You can choose between the pin or cup sensor by selecting from the dropdown. The pin sensor is £20.28 excluding VAT. The cup sensor is £22.77 excluding VAT.

It is very easy to replace the sensor on your Elite pH once it shows signs of calibration failure or fluctuating readings. No need to buy a whole new tester, just purchase a sensor at a much lower cost.

Replacing a sensor

  • Ensure you have dry hands.
  • Hold onto the ring with the CTS sensor facing you. Twist the ring clockwise. Set the ring aside for later.
  • Remove the old sensor module from the tester by gently pulling it away.
  • Match the four slots on the tester with the four tabs on the new sensor module and gently push the module into the slots.
  • Push the smaller O-ring fully onto the new sensor module. Push the other O-ring over the module and thread it into place by firmly twisting counter clockwise.
  • Your tester will now require calibration before use. You will have received a full instruction booklet with your tester that you can consult if need be.